Deploying a Unity Cluster

Building the Player

There are no special techniques involved in the build process. As long as you build the player with a Cluster-enabled Editor, the player will have the Cluster-enabled features.

Launching the Cluster

Distribute a copy of the player to the Master Node machine, and each of the Client Node machines. It is highly recommended to use the same player files all the time to ensure the simulation will not vary. Prepare a batch file for each node to launch the application with the following command line arguments.

These arguments trigger the player to run in Unity Cluster mode:

Master node

-server <number of clients> *:<pubport> *:* <timeout>

• Run this application as the master of the cluster network.
• Number of clients indicate the total number of slave will connect to the master. This do not included master. The master will not proceed until the number of clients connected is reach the indicated amount.
• timeout is optional. Its use is to tell how long server should wait for client’s signal to consider the network is disconnected.

Client node

-client <index> <masterip>:<pubport> <clientip>:<clientport> <timeout>

This run this application as one of the client nodes in the cluster network.

• index is the node index for this client in the network. Each Client Node should be assigned a unique index. The index normally relates to the node’s position in the display grid.
• masterip is the IP address of the Master Node machine. Do not use localhost, it will not resolve correctly.
• clientip and clientport is the IP address and port of the client machine. Use * for both for auto assignment, which is usually the case.
• pubport has to be identical to Master Node’s setup.
• timeout is optional. It can be used to tell the clients how long to wait for server’s signal before it assumes it has been disconnected from the network.

Additional Arguments

Testing locally

You can test cluster rendering by running multiple instances of your project on a single machine, launching each with the appropriate command line arguments as shown above.