The Spring Joint 2D component allows two GameObjects controlled by Rigidbody physics to be attached together as if by a spring. The spring will apply a force along its axis between the two GameObjects, attempting to keep them a certain distance apart.
|Enable Collision||Enable this property to enable collisions between the two connected GameObjects.|
|Connected Rigidbody||Specify the other object this joint connects to. Leave this as None to have the other end of the joint fixed at a point in space defined by the Connected Anchor property. Select the circle icon to the right to view a list of GameObjects to connect to.|
|Auto Configure Connected Anchor||Enable this property to automatically set the anchor location for the other object this joint connects to. You do not need to enter coordinates for the Connected Anchor property if you enable this property.|
|Anchor||Define where (in terms of x, y-coordinates on the Rigidbody 2D) the end point of the joint connects to the GameObject.|
|Connected Anchor||Define where (in terms of x, y-coordinates on the Rigidbody 2D) the end point of the joint connects to the other GameObject.|
|Auto Configure Distance||Enable this property to automatically detect the distance between the two GameObjects and set it as the distance that the joint keeps between the two GameObjects.|
|Distance||Set the distance that the spring should attempt to maintain between the two objects. (Can be set manually.)|
|Damping Ratio||Set the degree to suppress spring oscillation. In the range 0 to 1, the higher the value, the less movement.|
|Frequency||Set the frequency at which the spring oscillates while the GameObjects are approaching the separation distance you want (measured in cycles per second). In the range 0 to 1,000,000 - the higher the value, the stiffer the spring. Note: Setting Frequency to zero will create the stiffest spring type joint possible.|
|Break Action||Set the action taken when either the force or torque threshold is exceeded.|
|Break Force||Set the force threshold which if exceeded, will cause the joint to perform the selected Break Action. The default value is set to Infinity, which can never be exceeded and therefore the Break Action can never be taken while the threshold remains at this value.|
This joint behaves like a spring, while keeping a linear distance between two points. You set this via the Distance setting. Those two points can be two Rigidbody2D components or a Rigidbody2D component and a fixed position in the world. (Connect to a fixed position in the world by setting Connected Rigidbody to None). The joint applies a linear force to both rigid bodies. It doesn’t apply torque (an angle force).
조인트는 시뮬레이션된 스프링을 사용합니다. 스프링 강도 및 움직임을 다음과 같이 설정할 수 있습니다.
경직되어 있고 거의 움직이지 않는 스프링…
A high (1,000,000 is the highest) Frequency == a stiff spring.
A high (1 is the highest) Damping Ratio == a barely moving spring.
느슨하고 움직이는 스프링…
A low Frequency == a loose spring.
A low Damping Ratio == a moving spring.
When the spring applies its force between the objects, it tends to overshoot the distance you have set between them, and then rebound repeatedly, giving in a continuous oscillation. The Damping Ratio sets how quickly the objects stop moving. The Frequency sets how quickly the objects oscillate either side of the target distance.
이 조인트에는 한 가지 제약이 있습니다.
You can use this joint to construct physical objects that need to react as if they are connected together using a spring or a connection which allows rotation. For example:
Note: Spring Joint 2D uses a Box 2D spring-joint, which the Distance Joint 2D also uses with its frequency set to zero.