Version: Unity 6.1 Alpha (6000.1)
Language : English
Extracting animation clips
Curves

Loop optimization on Animation clips

A common operation for people working with animations is to make sure they loop properly. For example, if a character is walking down a path, the walking motion comes from an Animation clipAnimation data that can be used for animated characters or simple animations. It is a simple “unit” piece of motion, such as (one specific instance of) “Idle”, “Walk” or “Run”. More info
See in Glossary
. The motion might last for only 10 frames but that motion plays in a continuous loop. In order to make the walking motion seamless, it must begin and end in a similar pose. This ensures there is no foot sliding or strange jerky motions.

Animation clips can loop on pose, rotation, and position. Using the example of the walk cycle, you want the start and end points for Root TransformThe Transform at the top of a hierarchy of Transforms. In a Prefab, the Root Transform is the topmost Transform in the Prefab. In an animated humanoid character, the Root Transform is a projection on the Y plane of the Body Transform and is computed at run time. At every frame, a change in the Root Transform is computed, and then this is applied to the GameObject to make it move. More info
See in Glossary
Rotation and Root Transform Position in Y to match. You don’t want to match the start and end points for the Root Transform Position in XZ, because your character would never get anywhere if its feet keep returning to their horizontal pose.

Unity provides match indicators and a set of special loop optimization graphs under the clip-specific import settings on the Animation tab. These provide visual cues to help you optimize where to clip the motion for each value.

To optimize whether the looping motion begins and ends optimally, you can view and edit the looping match curves.

Viewing loop optimization graphs

In this example, the looping motion displays bad matches for the clip ranges, shown by the red and yellow indicators:

Red and yellow indicators show bad matches for looping
Red and yellow indicators show bad matches for looping

To see the loop optimization graphs, click and hold either the start or end indicator on the timeline. The Based Upon and Offset values disappear and one curve for each loop basis appears:

Looping graphs for bad matches
Looping graphs for bad matches

Optimizing looping matches

Click and drag the start or end point of the Animation Clip until the point appears on the graph where the property is green. Unity draws the graph in green where it is more likely that the clip can loop properly.

Position start and end points where the graph is green
Position start and end points where the graph is green

When you let go of the mouse button, the graphs disappear but the indicators remain:

Green indicators show good matches for looping
Green indicators show good matches for looping
Extracting animation clips
Curves