Version: 2021.3
LanguageEnglish
  • C#

Mathf.Repeat

Suggest a change

Success!

Thank you for helping us improve the quality of Unity Documentation. Although we cannot accept all submissions, we do read each suggested change from our users and will make updates where applicable.

Close

Submission failed

For some reason your suggested change could not be submitted. Please <a>try again</a> in a few minutes. And thank you for taking the time to help us improve the quality of Unity Documentation.

Close

Cancel

Switch to Manual

Declaration

public static float Repeat(float t, float length);

Description

Loops the value t, so that it is never larger than length and never smaller than 0.

This is similar to the modulo operator but it works with floating point numbers. For example, using 3.0 for t and 2.5 for length, the result would be 0.5. With t = 5 and length = 2.5, the result would be 0.0. Note, however, that the behaviour is not defined for negative numbers as it is for the modulo operator.

In the example below, the value of time is restricted between 0.0 and just under 3.0. When the value of time is 3, the x position will go back to 0, and go back to 3 as time increases, in a continuous loop.

using UnityEngine;

public class Example : MonoBehaviour { void Update() { // Set the x position to loop between 0 and 3 transform.position = new Vector3(Mathf.Repeat(Time.time, 3), transform.position.y, transform.position.z); } }

The example below shows different possible outputs.

using UnityEngine;

public class Example : MonoBehaviour { void Start() { // prints 4 Debug.Log(Mathf.Repeat(-1f, 5f));

// prints 0 Debug.Log(Mathf.Repeat(0f, 5f));

// prints 1 Debug.Log(Mathf.Repeat(1f, 5f));

// prints 0 Debug.Log(Mathf.Repeat(5f, 5f));

// prints 2 Debug.Log(Mathf.Repeat(12f, 5f));

// prints 1 Debug.Log(Mathf.Repeat(16f, 5f));

// prints 4 Debug.Log(Mathf.Repeat(19f, 5f)); } }