Wire-Pin tool settings

Customize the settings of the Wire-Pin tool to get the groom you want. For more information on the Wire-Pin tool and how to use it, refer to Wire-Pin tool and Move the hair with wires.

Note

In the Outliner, a wmWigWireFullNode, wmWigWirePinNode, or wmWigWireDeformerNode hold the guide curve(s).

Wire-pin Settings

Property		Description
Control Mode	Set the mode that the Wire-Pin tool works in.
	Full	Create guide curves for each selected strand. You can select and move each guide curve separately.
	Deformer	Create a single guide curve that binds the other strands of hair/fur to it. As you sculpt/deform/move the guide curve, the strands in the node move. Deformation of bound strands is relative to the guide curve.

Deformer Settings

Property	Description
Deformer Mode	Create or manipulate a wire-pin. This mode is only available when Deformer is selected in the Wire-pin Settings.
	Create Wire Pin	Create a wire-pin.
	Manipulate Wire Pin	Manipulate a wire-pin.
Selection Mode	Add or remove hairs from the wire-pin node or change which hair is the guide curve for the node. This mode is only available when Manipulate Wire Pin is selected.
	Add/Remove hairs	Add or remove hairs from the wire-pin node. You can paint with the brush to add hairs to the node. To remove hairs from the node, hold down Ctrl as you paint in Add/Remove Hairs mode.
	Move Wire	Change which hair is the control curve for your node. Click on the hair to select it as the guide curve. You can set any hair in the fur set as the control curve; it doesn't have to be one of the hairs within the wire-pin node.
Radius	Adjust the radius of the brush using the slider.
Falloff	Adjust the falloff of the brush using the slider.