Create Curves from Strands Options

Create a set of curves by converting strands to curves in the selected Fur node. Create an absolute number of curves, a ratio of the existing strands, or a density value.

Find these options at Wig > Curves > Create Curves from Strands.

For more information, refer to Create curves from strands.

Settings

Property	Description
Create Curves By	Choose how to convert strands to curves.
	Count	Convert an absolute number of strands to curves.
	Ratio	Convert a ratio of the existing strands to curves.
	Master Density	Convert a specific density value (cm2) of strands to curves.
Count	Set the absolute number of curves to create. This property is visible only if Create Curves By is set to Count.
Ratio	Set the ratio of existing strands to convert to curves. This property is visible only if Create Curves By is set to Ratio.
Master Density	Set the density value of curves to create. This property is visible only if Create Curves By is set to Master Density.

Advanced Settings

Property	Description
Minimum Curve Length	Convert only strands that are longer than the specified length.
Number of CVs	Set the number of CVs on each curve. If this property isn't enabled, curves default to the same number of CVs as the input strands.