Edge actions

This section of the ProBuilder toolbar provides access to ProBuilder editing actions that you can use in the Edge edit mode.

Note: Some actions also have extra options or custom settings available. These action buttons have a special indicator in the top right corner. The documentation for each action includes information about these options.

Bridge Edges

Use the Bridge Edges action to create a new face between two selected edges.

For more information, see the Bridge Edges action documentation.

Bevel

Use the Bevel action to split the selected edge(s) into two edges, with a new face between.

For more information, see the Bevel action documentation.

Connect Edges

Use the Connect Edges action to insert a new edge that connects the centers of each existing selected edge.

For more information, see the Connect Edges action documentation.

Extrude Edges

Use the Extrude Edges action to push a new edge out from each selected edge.

For more information, see the Extrude Edges action documentation.

Subdivide Edges

Use the Subdivide Edges action to divide the selected edge(s) into multiple edges.

For more information, see the Subdivide Edges action documentation.

Fill Hole

Use the Fill Hole action to create a new face that fills any holes that touch the selected edges.

For more information, see the Fill Hole action documentation.

Insert Edge Loop

Use the Insert Edge Loop action to add a new edge loop from the selected edge(s).

For more information, see the Insert Edge Loop action documentation.

Cut Tool

Use the Cut tool to create a new face on an existing Mesh.

For more information, see the Cut tool documentation.

Offset Edges

Use the Offset Elements action in the Edge edit mode to move the selected edge(s) according to the settings.

For more information, see the Offset Elements action documentation.

Set Pivot

Use the Set Pivot action to move the pivot point of this Mesh to the average center of the selected edges.

For more information, see the Set Pivot action documentation.