Legacy Documentation: Version 5.6 (Go to current version)
Audio Reverb Filter
Audio Effects
Other Versions

Audio Chorus Filter

Switch to Scripting

The Audio Chorus Filter takes an Audio Clip and processes it creating a chorus effect.

Properties

Property: Function:
Dry Mix Volume of original signal to pass to output. 0.0 to 1.0. Default = 0.5.
Wet Mix 1 Volume of 1st chorus tap. 0.0 to 1.0. Default = 0.5.
Wet Mix 2 Volume of 2nd chorus tap. This tap is 90 degrees out of phase of the first tap. 0.0 to 1.0. Default = 0.5.
Wet Mix 3 Volume of 3rd chorus tap. This tap is 90 degrees out of phase of the second tap. 0.0 to 1.0. Default = 0.5.
Delay The LFO’s delay in ms. 0.1 to 100.0. Default = 40.0 ms
Rate The LFO’s modulation rate in Hz. 0.0 to 20.0. Default = 0.8 Hz.
Depth Chorus modulation depth. 0.0 to 1.0. Default = 0.03.
Feed Back Chorus feedback. Controls how much of the wet signal gets fed back into the filter’s buffer. 0.0 to 1.0. Default = 0.0.

Details

The chorus effect modulates the original sound by a sinusoid low frequency oscillator (LFO). The output sounds like there are multiple sources emitting the same sound with slight variations - resembling a choir.

You can tweak the chorus filter to create a flanger effect by lowering the feedback and decreasing the delay, as the flanger is a variant of the chorus.

Creating a simple, dry echo is done by setting Rate and Depth to 0 and tweaking the mixes and Delay

Audio Reverb Filter
Audio Effects