Blend Trees
A common task in game animation is to blend between two or more similar motions. Perhaps the best known example is the blending of walking and running animations according to the character’s speed. Another example is a character leaning to the left or right as he turns during a run.
It is important to distinguish between Transitions and Blend Trees. While both are used for creating smooth animation, they are used for different kinds of situations.
Transitions are used for transitioning smoothly from one Animation State to another over a given amount of time. Transitions are specified as part of an Animation State Machine. A transition from one motion to a completely different motion is usually fine if the transition is quick.
Blend Trees are used for allowing multiple animations to be blended smoothly by incorporating parts of them all to varying degrees. The amount that each of the motions contributes to the final effect is controlled using a blending parameter, which is just one of the numeric animation parameters associated with the Animator Controller. In order for the blended motion to make sense, the motions that are blended must be of similar nature and timing. Blend Trees are a special type of state in an Animation State Machine.
Examples of similar motions could be various walk and run animations. In order for the blend to work well, the movements in the clips must take place at the same points in normalized time. For example, walking and running animations can be aligned so that the moments of contact of foot to the floor take place at the same points in normalized time (e.g. the left foot hits at 0.0 and the right foot at 0.5). Since normalized time is used, it doesn’t matter if the clips are of different length.
Using Blend Trees
To start working with a new Blend Tree, you need to:
- Right-click on empty space on the Animator Controller Window.
- Select from the context menu that appears.
- Double-click on the Blend Tree to enter the Blend Tree Graph.
The Animator Window now shows a graph of the entire Blend Tree while the Inspector shows the currently selected node and its immediate children.
This gives a graphical visualization of how the animations are combined as the parameter value changes (as you drag the slider, the arrows from the tree root change their shading to show the dominant animation clip).
You can select any of the nodes in the Blend Tree graph to inspect it in the Inspector. If the selected node is an Animation Clip the Inspector for that Animation Clip will be shown. The settings will be read-only if the animation is imported from a model. If the node is a Blend Node, the Inspector for Blend Nodes will be shown.
You can choose either 1D or 2D blending from the Blend Type menu; the differences between the two types are described on their own pages in this section.
Blend Trees and Root Motion
The blending between animations is handled using linear interpolation (ie, the amount of each animation is an average of the separate animations weighted by the blending parameter). However, you should note that root motion is not interpolated in the same way. See the page about root motion for further details about how this might affect your characters.