Legacy Documentation: Version 5.0
Networking Elements in Unity
RPC Details

Network Views

Suggest a change

Success!

Thank you for helping us improve the quality of Unity Documentation. Although we cannot accept all submissions, we do read each suggested change from our users and will make updates where applicable.

Close

Sumbission failed

For some reason your suggested change could not be submitted. Please try again in a few minutes. And thank you for taking the time to help us improve the quality of Unity Documentation.

Close

Cancel

Network Views are the main component involved in sharing data across the network. They allow two kinds of network communication: State Synchronization and Remote Procedure Calls.

Network Views keep watch on particular objects to detect changes. These changes are then shared to the other clients on the network to ensure the change of state is noted by all of them. This concept is known as state synchronization and you can read about it further on the State Synchronization page.

There are some situations where you would not want the overhead of synchronizing state between clients, for example, when sending out the position of a new object or respawned player. Since events like this are infrequent, it does not make sense to synchronize the state of the involved objects. Instead, you can use a remote procedure call to tell the clients or server to perform operations like this. More information about Remote Procedure Calls can be found on the RPC manual page.

Technical Details

A Network View is identified across the network by its NetworkViewID which is basically just a identifier which is negotiated to be unique among the networked machines. It is represented as a 128 bit number but is automatically compressed down to 16 bits when transferred over the network if possible.

Each packet that arrives on the client side needs to be applied to a specific Network View as specified by the NetworkViewID. Using this, Unity can find the right Network View, unpack the data and apply the incoming packet to the Network View’s observed object.

More details about using Network Views in the Editor can be found on the Network View Component Reference page.

If you use Network.Instantiate() to create your Networked objects, you do not need to worry about allocating Network Views and assigning them yourself appropriately. It will all work automatically behind the scenes.

However, you can manually set the NetworkViewID values for each Network View by using Network.AllocateViewID. The Scripting Reference documentation shows an example of how an object can be instantiated manually on every client with an RPC function and then the NetworkViewID manually set with AllocateViewID.

Networking Elements in Unity
RPC Details