Legacy Documentation: Version 4.5
Previous
Mesh Filter
Next
Skinned Mesh Renderer

Mesh Renderer

Switch to Scripting

The Mesh Renderer takes the geometry from the Mesh Filter and renders it at the position defined by the object’s Transform component.

Properties

Property: Function:
Cast Shadows (Pro only) If enabled, this Mesh will create shadows when a shadow-creating Light shines on it
Receive Shadows (Pro only) If enabled, this Mesh will display any shadows being cast upon it
Materials A list of Materials to render model with
Use Light Probes (Pro only) Enable probe-based lighting for this mesh
Anchor Override (Pro only) A Transform used to determine the interpolation position when the light probe system is used

Details

Meshes imported from 3D packages can use multiple Materials. All the materials used by a Mesh Renderer are held in the Materials list. Each submesh will use one material from the materials list. If there are more materials assigned to the Mesh Renderer than there are submeshes in the mesh, the first submesh will be rendered with each of the remaining materials, one on top of the next. At a cost of performance, this will let you set up multi-pass rendering on that submesh. Fully opaque materials, however, will simply overwrite the previous layers, costing performance for no advantage.

A mesh can receive light from the light probe system if the Use Light Probes option is enabled (see the light probes manual page for further details). A single point is used as the mesh’s notional position for light probe interpolation. By default, this is the centre of the mesh’s bounding box, but you can override this by dragging a Transform to the Anchor Override property. It may be useful to set the anchor in cases where an object contains two adjoining meshes; since each mesh has a separate bounding box, the two will be lit discontinuously at the join by default. However, if you set both meshes to use the same anchor point, they will be consistently lit.

Previous
Mesh Filter
Next
Skinned Mesh Renderer