Thank you for helping us improve the quality of Unity Documentation. Although we cannot accept all submissions, we do read each suggested change from our users and will make updates where applicable.
CloseFor some reason your suggested change could not be submitted. Please <a>try again</a> in a few minutes. And thank you for taking the time to help us improve the quality of Unity Documentation.
CloseSet the angular tolerance threshold (in degrees) for projection.
If the joint deviates by more than this angle around its locked angular degrees of freedom,
the solver will move the bodies to close the angle.
Setting a very small tolerance may result in simulation jitter or other artifacts.
Sometimes it is not possible to project (for example when the joints form a cycle).