The Reflect plugin for Revit

The Reflect plugin is available for the following versions of Revit:

  • 2018*
  • 2019
  • 2020
  • 2021

Revit 2018 is still supported but is not maintained due to Autodesk’s policy of supporting only the most recent three versions.

Installation

To install the plugin, run the Reflect installer and select your version or versions of Revit.

Unity Reflect installer

Once the Revit plugin is installed on your computer, you can start the Reflect service from inside Revit to begin real-time syncing.

Syncing

To start syncing Revit data with the Unity Editor:

  1. Open Revit. If prompted to grant permissions to the Unity plugin, select Load Once (or Always Load to avoid future prompts).

  2. Open the Revit project you want to sync with Reflect. If the Reflect plugin is installed, the ribbon includes a Unity tab:

    RevitUnityTab

  3. Select a 3D view to sync with Reflect.

  4. Click Start to launch the Reflect service.