Version: 2022.3
LanguageEnglish
  • C#

Rigidbody.AddTorque

Suggest a change

Success!

Thank you for helping us improve the quality of Unity Documentation. Although we cannot accept all submissions, we do read each suggested change from our users and will make updates where applicable.

Close

Submission failed

For some reason your suggested change could not be submitted. Please <a>try again</a> in a few minutes. And thank you for taking the time to help us improve the quality of Unity Documentation.

Close

Cancel

Switch to Manual

Declaration

public void AddTorque(Vector3 torque, ForceMode mode = ForceMode.Force);

Parameters

torque Torque vector in world coordinates.
mode The type of torque to apply.

Description

Adds a torque to the rigidbody.

Force can be applied only to an active rigidbody. If a GameObject is inactive, AddTorque has no effect.

The effects of the torques applied with this function are accumulated at the time of the call. The physics system applies the effects during the next simulation run (either after FixedUpdate, or when the script explicitly calls the Physics.Simulate method). Because this function has different modes, the physics system only accumulates the resulting angular velocity change, not the passed torque values. Assuming deltaTime (DT) is equal to the simulation step length (Time.fixedDeltaTime), and mass is equal to the mass of the Rigidbody the torque is being applied to, here is how the angular velocity change is calculated for all the modes:

  • ForceMode.Force: Interprets the input as torque (measured in Newton-metres), and changes the angular velocity by the value of torque * DT / mass. The effect depends on the simulation step length and the mass of the body.
  • ForceMode.Acceleration: Interprets the parameter as angular acceleration (measured in degrees per second squared), and changes the angular velocity by the value of torque * DT. The effect depends on the simulation step length but does not depend on the mass of the body.
  • ForceMode.Impulse: Interprets the parameter as an angular momentum (measured in kilogram-meters-squared per second), and changes the angular velocity by the value of torque / mass. The effect depends on the mass of the body but doesn't depend on the simulation step length.
  • ForceMode.VelocityChange: Interprets the parameter as a direct angular velocity change (measured in degrees per second), and changes the angular velocity by the value of torque. The effect doesn't depend on the mass of the body and the simulation step length.

Wakes up the Rigidbody by default. If the torque size is zero then the Rigidbody will not be woken up.

Additional resources: AddRelativeTorque, AddForce.

// Rotate an object around its Y (upward) axis in response to
// left/right controls.
using UnityEngine;
using System.Collections;

public class ExampleClass : MonoBehaviour { public float torque; public Rigidbody rb;

void Start() { rb = GetComponent<Rigidbody>(); }

void FixedUpdate() { float turn = Input.GetAxis("Horizontal"); rb.AddTorque(transform.up * torque * turn); } }

Declaration

public void AddTorque(float x, float y, float z, ForceMode mode = ForceMode.Force);

Parameters

x Size of torque along the world x-axis.
y Size of torque along the world y-axis.
z Size of torque along the world z-axis.
mode The type of torque to apply.

Description

Adds a torque to the rigidbody.

Force can be applied only to an active rigidbody. If a GameObject is inactive, AddTorque has no effect.

Wakes up the Rigidbody by default. If the torque size is zero then the Rigidbody will not be woken up.