Element Inspector overlay reference
Use the Element Inspector overlay to configure knots, tangents, and the flow of a spline.
To access the Element Inspector overlay, select knots or tangents on splines in the Scene view.
| Property | Description |
|---|---|
| Knot position | Set a knot's position. This property is visible only when you select knots. |
| Knot rotation | Set a knot's rotation. This property is visible only when you select knots. |
| Linear | Select the Linear tangent mode for a knot's tangents. |
| Auto | Select the Auto tangent mode for a knot's tangents. |
| Bezier | Select the Bezier tangent mode for a knot's tangents. |
| Bezier | Select the Bezier mode for a knot's tangents if the knot is in Bezier tangent mode. The following Bezier modes are available: |
| In | Set the magnitude and direction of the knot's In tangent. The In tangent defines the curvature of the segment that enters the knot. This property is visible only when you select knots. |
| Out | Set the magnitude and direction of the knot's Out tangent. The Out tangent defines the curvature of the segment that exits the knot. This property is visible only when you select knots. |
| Magnitude | Set the magnitude of a tangent. A tangent's magnitude determines how much that tangent affects the curvature of its respective segment. A high magnitude value increases a tangent's influence on a segment's curvature and a low value decreases it. This property is visible only when you select tangents. |
| Direction | Set the direction that a tangent points to from its knot. This property is visible only when you select tangents. |
| Link | Set knots to the same position and link them. |
| Unlink | Unlink knots. |
| Split | Divide a knot with two segments into two knots. |
| Join | Connect the ends of two splines to each other. |
| Reverse Spline Flow | Reverse the direction of a spline. |