Set Pivot icon Set Pivot (Edges)

Use the Set Pivot action to move the pivot point of this Mesh to the average center of the selected edges.

You can launch this action with the Ctrl/Cmd+J shortcut, or from the ProBuilder menu (Tools > ProBuilder > Geometry > Set Pivot).

Centering the pivot on selected Edges

In this example:

  • Left panel: The pivot point of the door is at its bottom-left corner.
  • Middle panel: Two edges are selected on the opposite side, so the Set Pivot action changes the pivot to the center of those top edges.
  • Right panel: The pivot point is now at the top right, even when in Object editing mode.