Edge Tools

This section of the ProBuilder toolbar provides access to ProBuilder editing tools that you can use in the Edge edit mode.

Note: Some actions also have extra options or custom settings available. These tool buttons have a special indicator in the top right corner. The documentation for each tool includes information about these options.

Bevel

Use the Bevel tool to split the selected edge(s) into two edges, with a new face between.

For more information, see the Bevel tool documentation.

Connect Edges

Use the Connect Edges tool to insert a new edge that connects the centers of each existing selected edge.

For more information, see the Connect Edges tool documentation.

Extrude Edges

Use the Extrude Edges tool to push a new edge out from each selected edge.

For more information, see the Extrude Edges tool documentation.

Bridge Edges

Use the Bridge Edges tool to create a new face between two selected edges.

For more information, see the Bridge Edges tool documentation.

Insert Edge Loop

Use the Insert Edge Loop tool to add a new edge loop from the selected edge(s).

For more information, see the Insert Edge Loop tool documentation.

Fill Hole

Use the Fill Hole tool to create a new face that fills any holes that touch the selected edges.

For more information, see the Fill Hole tool documentation.

Subdivide Edges

Use the Subdivide Edges tool to divide the selected edge(s) into multiple edges.

For more information, see the Subdivide Edges tool documentation.

Set Pivot

Use the Set Pivot tool to move the pivot point of this Mesh to the average center of the selected edges.

For more information, see the Set Pivot tool documentation.