Customize a table prop

You can change the width and height of the default table prop by going to More Settings > Table. You can also replace it with your own model by replacing the table.obj file in the props folder with your own OBJ file.

Note

Your file must be triangulated (contain only triangles) and be in the OBJ format.

Sub-mesh structure

To make sure there's no deformation, your mesh must have the following structure:

The names of the sub-meshes must be:

• table_Base_NorthEast
• table_Base_North
• table_Base_NorthWest
• table_Base_East
• table_Base_Center
• table_Base_West
• table_Base_SouthEast
• table_Base_South
• table_Base_SouthWest
• table_Top_NorthEast
• table_Top_North
• table_Top_NorthWest
• table_Top_East
• table_Top_Center
• table_Top_West
• table_Top_SouthEast
• table_Top_South
• table_Top_SouthWest

Important

If you change this structure, deformation can affect your prop.