Below are some tips for designing character models to give optimal rendering speed.
You should use only a single skinned Mesh Renderer for each character. Unity optimizes animation using visibility culling and bounding volume updates and these optimizations are only activated if you use one Animation component and one skinned Mesh Renderer in conjunction. The rendering time for a model could roughly double as a result of using two skinned meshes in place of a single mesh and there is seldom any practical advantage in using multiple meshes.
You should also keep the number of Materials on each mesh as low as possible. The only reason why you might want to have more than one Material on a character is that you need to use different shaders for different parts (eg, a special shader for the eyes). However, two or three materials per character should be sufficient in almost all cases.
A bone hierarchy in a typical desktop game uses somewhere between fifteen and sixty bones. The fewer bones you use, the better the performance will be. You can achieve very good quality on desktop platforms and fairly good quality on mobile platforms with about thirty bones. Ideally, keep the number below thirty for mobile devices, and don’t go too far above thirty for desktop games.
The number of polygons you should use depends on the quality you require and the platform you are targeting. For mobile devices, somewhere between 300 and 1500 polygons per mesh will give good results, whereas for desktop platforms the ideal range is about 1500 to 4000. You may need to reduce the polygon count per mesh if the game has lots of characters on screen at any given time.
When animations are imported, a model’s inverse kinematic (IK) nodes are baked into forward kinematics (FK) and as a result, Unity doesn’t need the IK nodes at all. However, if they are left in the model then they will have a CPU overhead even though they don’t affect the animation. You can delete the redundant IK nodes in Unity or in the modeling tool, according to your preference. Ideally, you should keep separate IK and FK hierarchies during modeling to make it easier to remove the IK nodes when necessary.