Legacy Documentation: Version 4.6.2
Language: English
Navigation and Pathfinding
Enabling a Character to Navigate

Navigation Meshes

Suggest a change

Success!

Thank you for helping us improve the quality of Unity Documentation. Although we cannot accept all submissions, we do read each suggested change from our users and will make updates where applicable.

Close

Sumbission failed

For some reason your suggested change could not be submitted. Please try again in a few minutes. And thank you for taking the time to help us improve the quality of Unity Documentation.

Close

Cancel

A pathfinding system needs a way to represent which parts of the game world can be reached by a character and also a way to determine the possible routes between any two points and choose the best. A mesh (similar to the ones used for 3D graphics) is a good solution to both problems. The reachable area is defined by the polygons of the mesh, while the possible paths through the mesh are conveniently broken down into hops between adjacent polygons. In theory, the same mesh that is used for the floor graphics can also be used for navigation. In practice, the graphical mesh is usually too detailed and consequently inefficient for navigation. For this and other reasons, an AI system usually supplements the floor mesh with a simpler, invisible mesh known as a navigation mesh (or “navmesh” for short). Fortunately, there are techniques to generate an efficient navmesh automatically from a graphical floor mesh and a few numeric parameters. The process of computing a navmesh in this way is known as baking.

In Unity, navmesh generation is handled from the Navigation window (menu: Window > Navigation). If you select the Object tab in the window, you will see something like the following:-

The Scene Filter options simply restrict the selection of objects shown in the Scene view and Hierarchy panel. The other options apply to the selected scene object(s); broadly, they allow you to include or exclude an object within the walkable area of the navmesh. You should mark objects to be included in the navmesh as Navigation Static. You can then set the Navigation Layer to Default if you want the area to be walkable or to Not Walkable otherwise. Typically, the walkable areas correspond to floors, ramps and bridges in the game world, while non-walkable areas correspond to walls and other impassable obstacles.

Selecting Bake gives you further options for navmesh generation on a separate tab:-

Of particular note are the General settings. The Radius determines how close a navigating character can get to a wall and consequently the width of the narrowest gap between two walls that can it can squeeze through. The Height refers to the height of the “ceiling” above the navmesh surface - an area may not be reachable simply because there is not enough headroom for the character. The Max Slope parameter sets the threshold of steepness where a ramp becomes a wall while the Step Height is the maximum height of bump or step in the floor surface that is ignored by the character (any step greater than this height results in a disconnected walkable area rather than a continuation of the same area).

With these parameters set, you can click the Bake button to compute the navmesh. The baking usually takes place very quickly and the resulting navmesh will be shown in the Scene as an overlay on the underlying level geometry. You may need a few attempts based on what you see in the scene before you get the settings for the navmesh just right.

Navigation and Pathfinding
Enabling a Character to Navigate