Version: 2018.3 (switch to 2019.1)
LanguageEnglish
  • C#

WebCamTexture.autoFocusPoint

Suggest a change

Success!

Thank you for helping us improve the quality of Unity Documentation. Although we cannot accept all submissions, we do read each suggested change from our users and will make updates where applicable.

Close

Submission failed

For some reason your suggested change could not be submitted. Please <a>try again</a> in a few minutes. And thank you for taking the time to help us improve the quality of Unity Documentation.

Close

Cancel

public Nullable<Vector2> autoFocusPoint;

Description

This property allows you to set/get the auto focus point of the camera. This works only on Android and iOS devices.

Vector2.x and Vector2.y components are relative values in the range 0..1 with the origin (0, 0) positioned at the bottom left corner of the texture. This property can be set when the current texture is playing (after WebCamTexture.Play method has been called). After a new value has been set, the device camera automatically refocuses using the new auto focus point. After refocusing, the camera focus is then locked. In order to disable use of the focus point and switch back to continuous auto-focus mode, the autoFocusPoint property should be set to null. If this feature is not supported by the camera device or if it is currently not possible to focus (for example because the previous focus attempt has not yet finished) then the previous value for the focus point setting is not changed. Setting this property to a value where either x or y is outside of the range 0..1 causes the focus point to be reset to null and the camera to be switched back to continuous auto-focus mode.

Note: this feature may not be supported by front-facing camera devices.

See Also: WebCamDevice.isAutoFocusPointSupported.

Did you find this page useful? Please give it a rating: