Legacy Documentation: Version 2018.2 (Go to current version)
LanguageEnglish
  • C#

ConfigurableJoint.projectionDistance

Other Versions
Leave feedback
Suggest a change

Success!

Thank you for helping us improve the quality of Unity Documentation. Although we cannot accept all submissions, we do read each suggested change from our users and will make updates where applicable.

Close

Submission failed

For some reason your suggested change could not be submitted. Please <a>try again</a> in a few minutes. And thank you for taking the time to help us improve the quality of Unity Documentation.

Close

Cancel

Switch to Manual
public float projectionDistance;

Description

Set the linear tolerance threshold for projection.

If the joint separates by more than this distance along its locked degrees of freedom, the solver will move the bodies to close the distance.

Setting a very small tolerance may result in simulation jitter or other artifacts.

Sometimes it is not possible to project (for example when the joints form a cycle).

Did you find this page useful? Please give it a rating:

Is something described here not working as you expect it to? It might be a Known Issue. Please check with the Issue Tracker at issuetracker.unity3d.com.

Copyright © 2018 Unity Technologies. Publication: 2018.2-002P. Built: 2019-01-17.
TutorialsCommunity AnswersKnowledge BaseForumsAsset StoreLegalPrivacy PolicyCookiesDo Not Sell or Share My Personal Information