Legacy Documentation: Version 5.2
LanguageEnglish
  • C#
  • JS

Script language

Select your preferred scripting language. All code snippets will be displayed in this language.

WheelCollider.forceAppPointDistance

Suggest a change

Success!

Thank you for helping us improve the quality of Unity Documentation. Although we cannot accept all submissions, we do read each suggested change from our users and will make updates where applicable.

Close

Sumbission failed

For some reason your suggested change could not be submitted. Please try again in a few minutes. And thank you for taking the time to help us improve the quality of Unity Documentation.

Close

Cancel

Switch to Manual
public var forceAppPointDistance: float;
public float forceAppPointDistance;

Description

Application point of the suspension and tire forces measured from the base of the resting wheel.

This is specified as a distance along the local up vector of the vehicle's rigid body from the base of the wheel at its rest coordinate (the rest coordinate of the wheel is determined by the value WheelCollider.spring.targetPosition). This parameter simulates the effective roll center of the suspension geometry. For a standard family car the value of forceAppPointDistance should be tuned to place the application point approximately 0.3m below the rigid body center of mass. Moving the application point downwards introduces more roll when cornering, while moving it upwards results in less roll when cornering. The force application point is typically below the rigid body center of mass.

Please note that having this parameter equal to zero could be undesirable as it contributes to simulation instability in certain configurations. Once you observe your vehicle failing to go asleep resting on flat surface, exhibiting jittering behavior or drifting along the surface when no user input is applied, check the forceAppPointDistance values. In the editor, when a WheelCollider game object is selected, there is a green spherical gizmo displayed to show where the force application point is at the moment. Try increasing forceAppPointDistance value gradually, until you're satisfied with the result.